Replacing the Fuser

1. Power the printer off, and unplug the power cord.


---

	The fuser is hot. To avoid personal injury, allow a minimum of 30 minutes for it to cool down before proceeding.

---

2. Open the rear access cover by pulling it downward.

3. Unfasten the white strap from the left side of the printer and remove the bottom of the strap from the rear access cover. The top of the strap will stay attached to the printer.

4. Remove the rear access cover by lifting up the right side of the cover, then sliding the cover to the right.

5. Loosen and remove the screws that hold the fuser in place.

6. Slide the fuser out of the printer.

7. Discard the old fuser in the trash, or recycle it. For information on recycling, visit www.xerox.com/office/recycle.

8. Gently slide the new fuser into the printer. Make sure that the fuser bolts are in line with the tracks in the printer, and that the cord is not stuck on the side the fuser.

9. Tighten the screws that hold the fuser in place.

10. Attach the rear access cover by sliding the right side into place, and then securing the left side.

11. Secure the white strap back in place by sliding it through the plastic holdings and securing it onto the tab on the rear access cover.

12. Close the rear access cover.

13. Plug the printer in, and power it back on.

To order a fuser in the U.S. and Canada note the following part number 126E02480 (110V) and call 1-800-835-6100; at the first prompt press 9, at the second prompt press 3. The part number for a 220 Volt fuser is 126E02490.